HEIDENHAIN IK 5294 - Manual (Page 261)

241
1
0
Supervisor Setup
Chapter 10:
Supervisor Setup
Setup screens are often made available to the supervisor by the OEM or Metronics distributor for custom-
izing display and some measurement parameters. The specific screens that are available are determined for
each system by the OEM or distributor responsible for system setup and maintenance. A collection of setup
screens typically made available to supervisors is included in this chapter. Some of these screens can also
be made available to the end-users by the supervisor. The setup screens omitted from this chapter are not
intended for supervisors or end-users. Setup screens presented in this chapter are listed below:
Tools/Customize menu item screens
Including a startup message ...............................................................242
Customizing colors ............................................................................243
Specifying on-screen help tips ...........................................................247
Specifying error messages .................................................................248
Specifying status bar information ......................................................250
Customizing toolbars .........................................................................251
Tools/Options menu item screens
Setting up programming parameters ..................................................256
Specifying the maximum program executions ..................................259
Restricting access to setup screens ....................................................260
Configuring measurement parameters ...............................................262
Displaying parts and probe position ..................................................264
Configuring joystick and footswitch buttons .....................................269
Setting the display of resolution, time and date .................................272
Specifying encoder parameters ..........................................................273
Specifying file names, locations and backups ...................................274
Setting serial port, machine zero and general parameters ..................279
Setting up the optical probe ...............................................................282
Setting up the crosshair probe ............................................................283
Tools/CNC menu item screens
Setting up the joystick ........................................................................284
10 Supervisor setup OE.indd 1 5/9/2005 10:03:32 AM