Scaling, Gutter, Creating a gutter – Kyocera Ecosys m2040dn User Manual
Page 55: Scaling -2, Gutter -2, Creating a gutter -2
Layout
Printer Driver
6-2
2
In the Pages per sheet list, select the number of pages to print on each sheet of
paper.
3
In the Layout list, select the direction the pages should flow.
4
If you want to print a border around each page, select Print borders.
5
Click OK to return to the Print dialog box.
6
Click OK to start printing.
Scaling increases or decreases text and graphics on a page.
You can also select a gutter setting that enlarges the margins to accommodate
manual stapling or manual hole punch.
If other Layout tab options are selected, Scaling is unavailable.
1
In the Layout tab, type or select a scaling percentage from 20 to 500.
2
Click OK to return to the Print dialog box.
3
Click OK to start printing.
Gutter increases the margins around your text and graphics on the left side and
at the top of the printed sheet. Gutter is often used for binding, hole punch, or
stapling to make a print job easier to read. This creates a larger margin space
by shifting the printable area to the right, or down, as much as one inch (25.4
mm).
Gutter width displays the unit of measurement in inches or millimeters. You
can change the Units setting in the User Settings dialog box, accessed from
Device Settings.
1
In the Layout tab, click Gutter.
2
Under Gutter width, type or select a value between 0.20 to 1.00 inches (5.0 to
25.4 mm).
Short edge (top)
This selection modifies the outside margin on the top edge of the page.
Long edge (left)