Micromod MOD: 30MLTraining Manual - Manual (Page 100)

Training Manual
PID Loop Lab
• Click on the input of the VCI block. See the figure above.
Figure 6 .28.
Connecting blocks
• The connection will now be complete. The connection line will have the source
name and destination name displayed right on it as shown in the above figure.

The input connection points are on the left side of the blocks and the output connection
points are on the right hand side.
There might be more than one input or output for each block. All the inputs or outputs
need not be shown as connections attached to the block. To see all the inputs or outputs of
a block, you need to click right on the block in the connection mode.
As an example, the figure below shows the possible inputs of the PID block (destinations
for inputs into this block).
Figure 6 .29.
Choose parameter
for connecting
16. Connect the corrected flow as the process variable input the PID block.
• Let us take Right angle connector this time. The right angle connector will connect
the blocks by horizontal and vertical lines instead of making a point to point
straight connection.
• Select the right angle connector from the Algorithms menu as shown below:
6 - 20