Micromod MOD: 30MLTraining Manual - Manual (Page 21)

Training Manual
MOD 30ML Operation Lab 2
2.3.2 Scroll through the displays:
Step Activity Look For
1 The first display as shown in the
previous page is the main batch
display. This is the display where we
will start the batch. But before that,
we will scroll through the other
displays to get an overview. Note that the batch is in AUTO mode and is not
running right now (OFF). The setpoint is in local
(LOC) mode.
2 Press the TAG key once to go to the
TIC-100 temperature control loop
display. See the next figure.
Read the temperature of the product.
Read the output. Press the SCROLL
key to show the setpoint at the
bottom.
Press the TAG key again to go to
TIC-101 control loop display. See
the next figure.
Read the process, setpoint and
output values.
Press the TAG key to go to the next
display. See the next figure.
This is the Master temperature controller.
Master temperature controller TIC-100 setpoint
100ºF.
This is the Slave temperature controller.
Slave temperature controller TIC-101 setpoint
200ºF.
Setpoint is in Remote mode (REM). Its value is
same as the output value of the TIC-100 loop.
This display shows the Flow rates of Product A and
B and also the Level value in inches.
Product A and B flow 0 GPM
Level in vessel 0.0” H
2
O
Figure 2 .4.
TIC-100, TIC-101
and Flow/Level
Displays
2 - 5