Micromod MOD: 30MLTraining Manual User Manual
Page 205
Advertising
Training Manual
Supervisory Message Lab
13. Double-click on StepMgr
A list of all the possible connection
parameters in the Sequence block appears
14. Move the scroll bar at the bottom of the window all the way to
the right. You should see the Inputs and Outputs you added to
the SEQ block in the Sequence lab.
15. Select CtrlMode and click OK
This sends either a “0” or “1” to the
controller mode to switch between Manual
and Auto, when the message is triggered.
16. Drag the cursor to the TEMP CONTROL compound and select it
13 - 7
Advertising
This manual is related to the following products: