Micromod MOD: 30MLTraining Manual - Manual (Page 166)

Training Manual
Peer-to-Peer Communications
Configure the Second Instrument:
1. Install an ICN Module into the controller’s slots 7 and 8 and set its address to 2.
2. Add an Input Communications Block to the instrument:
• Select the IC (Input Communications) block from the Algorithms window and add it to the
document, near the PID block. Note: The IC blocks can only be added from within a Loop
Compound.
Figure 10 .16.
Algorithms menu
3. Configure the Input Communication Block:
• Double-click on the IC block to configure: The IC block Properties will open.
• Click on the pull-down menu to configure the Data Type of the signal being received from the
other instrument.
Figure 10 .17.
IC block
10 - 10