Micromod MOD: 30MLTraining Manual - Manual (Page 44)

Training Manual
Single Loop Template Lab
key to set the range at 200. Then press
ENT Significant Digit to flash, indicating you can
change that digit. Each time you press the FST
key the flash digit will move one digit to the left.
Pressing one of the arrows will cause the flashing
digit to ramp up or down.
12 Press NXT EU LABEL will be displayed on line 2.
Figure 3 .17.
13 Using the UP/DOWN keys and NXT key,
spell out GPM
Then press ENT Up to a 4 character label to appear after process
input value. First character entered becomes
leftmost character
14 Press NXT
LO QUAL
is displayed on line 2
15 Using the UP/DOWN keys enter -20.0 as
low quality limit. Then press ENT Result is set BAD if it goes below this value.
Figure 3 .18.
3 - 18