Micromod MOD: 30MLTraining Manual - Manual (Page 192)

Training Manual
Sequence Lab
Figure 12 .19.
SEQ Properties -
Steps Tab
Step number
Step name
Step transition logic
Outputs
Step number
Step name
Step transition logic
Outputs
• Click on the Add button. The Specify Data for this Step dialog will be displayed:
Figure 12 .20.
Specify Step dialog
• Type IDLE in the Step Name field.
• Type the step logic expression in the Transition Expression field:
IF StartPB && !Draining THEN Charge
In the above expression StartPB and Draining are inputs, and Charge is the step name.
• Click on the first blank field under the Data column in the Output Data window. Define
values for each output as shown in the above figure. These are the values each output
will assume when the sequence enters this step.
12 - 14