Micromod MOD: 30MLTraining Manual - Manual (Page 186)

Training Manual
Sequence Lab
• Click on the Add button at the bottom. This will open the Specify Input Data dialog box
as shown below:
Figure 12 .11.
Specify Input dialog
• Type StartPB (Start Push Button) in the Name field.

One of the powerful attributes of the Sequence block is the ability to assign names to
inputs, then use the names in the step logic. This makes it very easy for someone to
look at the block and understand the logic.
• Click on the down arrow in the Data Type field and select Discrete from the list. The
dialog should look like the figure below:
Figure 12 .12.
Specify Input dialog
• Click on OK to close this dialog. The input you just added will be listed under the Inputs
tab of the SEQ Properties dialog as shown below.
This discrete input will be used for starting the batch and will be later connected to the
StartPB digital input module wired to the Start Push Button on the control panel.
12 - 8