Micromod MOD: 30MLTraining Manual - Manual (Page 57)

Training Manual
MOD 30ML Diagnostics Lab
2 Press DOWN key once. If PASSWORD is
not displayed on line 2, go to step 5.
Otherwise continue with Step 3.
3 Use UP key three times to select the
PASSWORD and then use ENT to
enter. See the next set of figures Lines 1 and 2 will display CURRENT LEVEL and Line 6
will display CONFIG indicating that the controller is in
configuration mode.
4 Press ENT again to enter
Configuration mode.
Lines 1 and 2 will display DEV STATE and INSTATE
(Instrument state). Line 6 will display RUN indicating
that the controller is running a valid database.
Figure 4 .4.
5 Press the NXT key until COMMANDS is
displayed on line 2.
You will be in DEV STAT menu mow. See the
sequence of figures below:
You can issue commands to the controller from
this menu.
Figure 4 .5.
4 - 5