Micromod MOD: 30MLTraining Manual User Manual
Page 185
Advertising
Training Manual
Sequence Lab
6.
Configure the Sequence block:
• Double-click on the SEQ block to open the SEQ Properties dialog as shown below:
Figure 12 .9.
SEQ Properties -
General Tab
• Type a tag name and description as shown above under the General tab.
7.
Add Sequence Inputs
• Click on the Inputs tab of this dialog. Refer to the next figure:
Figure 12 .10.
SEQ Properties -
Inputs Tab
Click here to add inputs
Click here to add inputs
12 - 7
Advertising
This manual is related to the following products: