Micromod MOD: 30MLTraining Manual - Manual (Page 28)

Training Manual
Single Loop Template Lab
3.3 Instructions
3.3.1 Power up the controller
1. We will remove the memory module if any from the controller. Loosen 2 screws on
Faceplate on controller and remove Instrument from housing. Remove Memory module from
Instrument. Return Instrument to housing. Removing the memory module will prevent
downloading of configuration from the memory module in case the instrument is powered
up.
2. Power-up Instrument if it is not already powered up.
3.3.2 Acknowledge Alarms:
3. Press ALARM key. This will list all unacknowledged and active acknowledged alarms and
diagnostics that are currently present in the controller.
4. Read lines 1 and 2 on the display. These lines describe the alarm.
5. Read line 3. This line will describe condition of alarm. If line 3 displays UAK then the
current alarm displayed is an unacknowledged alarm. If line 3 displays ACT then the alarm
is acknowledged, but still active.
Figure 3 .2.
MOD 30ML Alarm
UnAcKnowledged
Alarm
6. Acknowledge the alarm: Press the key next to line 3 (the AUTO or “A” key) to
acknowledge. This will change the condition of the alarm. For example, if the alarm was
unacknowledged (UAK), then the message will change to ACT if the alarm is still active
or CLR if the alarm cleared.
3 - 2