Micromod MOD: 30MLTraining Manual - Manual (Page 156)

Training Manual
Debug Lab
• Type W PID1.SP 90 F in the command line and press Enter to change the value
of the setpoint to 90. The instrument will report the current value of the setpoint.
• Note that in this case, the “F” denoting floating point data type is not required,
though it is required for attributes such as an expression block input, because the
data type is variable. Please refer to table 2-1 in IB-23G600 for data type details.
Figure 9 .14.
Instrument Status
• Close the Instrument Status Viewer by clicking on the Exit button.
9 - 10