Micromod MOD: 30MLTraining Manual - Manual (Page 99)

Training Manual
PID Loop Lab
6.3.3 Connecting the blocks:
15. The next step is to connect the blocks together to realize the control loop shown in Figure
6.1.
• Click on the Multi-Segment connection item on the Algorithms menu to enable
connection mode. See figure below:
Figure 6 .25.
Algorithm -
Connection
• Move to the workspace on the right and click on the AIN block’s (FT-100 –
source block) output connection point as shown in the next figure. Notice that
moving the cursor over the output of a block, shows a fly-by box. This box shows
the name of the output (for example, in this case MODOUT).
Figure 6 .26.
Connecting blocks
• Move the cursor to the VCI block’s (destination block FY-100) input now.
Moving the cursor will draw a line.
Figure 6 .27.
Connecting blocks
• You will get a fly-by box that will say MODIN when you move over the input.
6 - 19