Micromod MOD: 30MLTraining Manual - Manual (Page 152)

Training Manual
Debug Lab
• Click on OK. Try changing the Set point and Mode of the Controller in the same
way.

Edit – Debug Cursor: There are two different modes for the cursor during Debug.
The default cursor type after entering Debug mode is “Debug” and the cursor will be
white. Refer to the following figure. During this mode, you cannot edit the document –
cannot move blocks, resize them or open them etc.
To be able to edit during the debug mode, click once on the cursor/selection button on the
Draw toolbar. The cursor will appear black now. Now you can edit the document, add
objects, open a loop compound or close it, etc. If you now double-click on the PID block,
it will display the PID block properties.
Figure 9 .8.
Edit / Debug Cursor
• Click on the cursor again to change its type to Debug mode.

You can also add graphic objects such as bar-graphs, trends, color changes to the
Modcell / MOD 30ML documents (strategy) and can animate in Debug mode. We will
do that later in a different lab.
9 - 6