Micromod MOD: 30MLTraining Manual - Manual (Page 82)

Training Manual
PID Loop Lab
6.3 Instructions
Follow these instructions step-by-step to configure a simple PID loop:
6.3.1 Getting started
1. Launch ViZapp. Select Programs from the Windows Start menu. Select ViZapp from
the menu. The ViZapp configurator will launch as shown in the next figure. As you will
notice, the configurator will be blank with no workspace loaded on the screen.
Figure 6 .2.
ViZapp
Configurator
• Note that the configurator screen has two frames (left and right).
2. We will create a new Workspace and a new project in this step. Click on the File
menu on the menu bar at the top. Select New from the drop-down menu as shown in the
next figure:
Figure 6 .3.
File-New
6 - 2