Micromod MOD: 30MLTraining Manual - Manual (Page 210)

Training Manual
Supervisory Message Lab
3. Double-click on the StepMGR block
4. Change the Mode from Auto to Manual, and then change the
Current Step from Idle to Heat.
Did the PID controller come out of
manual? Is the setpoint 90?
5. Now change the Current Step from Heat to Cool. Did the setpoint change to 20?
6. Finally, change the Current Step to Drain. Did the PID controller change to manual
mode? Is the setpoint zero?
7. Remember to stop Debug mode when you are done with the lab.
13 - 12