Micromod MOD: 30MLTraining Manual - Manual (Page 11)

Training Manual
MOD 30ML Front Face Familiarization Lab
1.4.3 Operating the Loop display
Left Bar will display the Process variable
Middle Bar will display the setpoint
Right Bar will display the control output
Line 1 will display the loop tag = FIC-100
Line 2 will display the process input and units = 0.00 GPM
Line 3 will display the control mode = MAN (manual)
Line 4 will display the setpoint mode = LOC (local)
Line 5 will indicate what value is displayed on line 6 = SP (setpoint)
Up/Down arrows indicate that the value on line 6 = W/V
can be manually altered
Line 6 will display the value indicated by line 5 = 0.00 %
1.4.4 Operating the Auto/Manual key
Step Procedure Comments
1. Press the Auto key
You will notice that line 3 changes to AUT and the
UP/DOWN arrows disappear indicating that
manual manipulation of the output is not possible.
2. Press the Manual key.
You will notice that line 3 changes to MAN and the
UP/DOWN arrows reappear indicating that manual
manipulation of the output is possible.
1 - 5