Micromod MOD: 30MLTraining Manual - Manual (Page 148)

Training Manual
Debug Lab
9.2 Objectives
In this lab we will run the PIDLAB document in debug mode using Vizapp Designer. We
will also read diagnostics from the instrument and acknowledge them from ViZapp using
the Status Viewer. After completing this lab, you should know how to:
• Run the Modcell/MOD 30ML document in debug mode by communicating with
the instrument.
• Start and use the Status Viewer to read and write instrument attributes.
Figure 9 .2.
Instrument Status
Viewer
9.3 Instructions
9.3.1 Part A
1. Launch ViZapp Designer if it was not running already. Open the PIDLAB instrument
document. The document (strategy) will open as shown in the figure below: (the position
and size of the blocks might be different). This is a static display.
2. Start Debug for this display:
• Select Project – Start Debug Mode from the menu bar at the top.
If you get perpetual communication error boxes popping up, force the server closed,
acknowledge the remaining pop-ups and correct the communication problem before
launching Debug Mode again.
9 - 2