Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 106)

52 Brocade Network Advisor IP User Manual
53-1002947-01
Logical chassis cluster mode discovery
4
Administratively removing a node from a logical chassis cluster
You can remove a node from a logical chassis cluster by using the Network OS command line
interface. For instructions, refer to the Network OS Administrator’s Guide and the Network OS
Command Reference, versions 4.0 or later.
Once the node is removed, all configurations corresponding to that node are removed from the
cluster configuration database.
The deleted node gets rebooted automatically and boots in VCS-disabled mode.
The deleted node also gets marked as missing in the cluster.
The Management application initiates auto-discovery immediately, and the deleted node gets
rediscovered in its current state.
As an example, Figure 8 shows the Discover Setup - IP dialog box before the administrator removes
a node from the cluster.
FIGURE 8 Discover Setup - IP dialog box before removal of node
Figure 9 shows the Discover Setup - IP dialog box after the administrator has removed the node
with the IP address of 172.26.5.130 from its logical chassis cluster.
FIGURE 9 Discover Setup - IP dialog box after disabling the node from logical chassis cluster
Figure 10 shows the Discover Setup - IP dialog box after The Management application has
performed rediscovery. The node with the IP address of 172.26.5.130 is shown as a degraded link.