Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 1220)

1166 Brocade Network Advisor IP User Manual
53-1002947-01
Configuration rules
38
Editing a user-defined configuration condition
NOTE
You cannot edit a predefined configuration condition.
1. Select Monitor > Policy Monitor.
The Policy Monitor dialog box displays.
2. Click Edit.
The Edit Monitor dialog box displays.
3. Click the Switch/Router Checks tab.
4. Select the configuration rule you want to edit in the Available Checks list and click Edit.
The Edit Configuration Rule dialog box displays.
5. Select the user-defined condition you want to edit and click Edit.
The Edit Condition dialog box displays.
6. Change the user-defined name for the rule in the Name field, if necessary.
The name must be unique. The name cannot be over 128 characters. The only special
character allowed is an underscore (_).
7. Change the description of the rule in the Description field, if necessary.
The description cannot be over 1, 024 ASCII characters.
8. To edit a configuration condition, repeat step 8 through step 13 of “Adding a configuration
condition” on page 1163.
9. Click OK on the Edit Condition dialog box.
10. Click OK on the Edit Configuration Rule dialog box.
11. Click OK on the Edit Monitor dialog box.
The updated policy monitor displays in the Monitors table.
12. Click Close on the Policy Monitor dialog box.