Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 626)

572 Brocade Network Advisor IP User Manual
53-1002947-01
Network OS switches in VCS mode
18
Viewing switches in VCS mode
1. Launch the DCB Configuration dialog box using one of the following methods:
• Select Configure > DCB from the menu bar.
• Right-click the DCB switch from the device tree, and select Configure > DCB.
• Right-click the DCB switch from the topology map and select Configure > DCB.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select a Network OS switch in the DCB Products/Ports table and click View.
The View Switch dialog box displays, allowing you to view the Network OS switch parameters.
3. Click one of the following tabs and refer to the appropriate corresponding table for a
description of the feature parameters.
• QoS — Refer to “Viewing QoS parameters on the Network OS switch” on page 572.
• FCoE — Refer to “Viewing FCoE parameters on the Network OS switch” on page 573.
• VLAN Classifiers — Refer to “Viewing VLAN classifiers and rules parameters on the Network
OS switch” on page 574.
• LLDP-DCBX — Refer to “Viewing LLDP-DCBX parameters on the Network OS switch” on
page 574.
• 802.1x — “Viewing the 802.1x parameter on the Network OS switch” on page 575.
Viewing QoS parameters on the Network OS switch
Table 72 describes the parameters that displays on the View Switch dialog box - QoS tab.
NOTE
Network OS switches in VCS mode support only the DCB map. Network OS switches in standalone
mode supports both the DCB and Traffic Class maps.
TABLE 72 QoS configuration parameters on VCS switch
Map Type Displays the map type: DCB or Traffic Class for a Standalone Network OS
switch or DCB for Network OS switches in VCS mode.
DCB Maps list Displays the following map information:
•
Name — The name of the map.
•
Precedence — The precedence number that determines the map’s
priority. Valid values are from 1 through 100.
•
Fabric Remap Priority — The fabric remap priority of the port. Valid
values are CoS 0 through CoS 6, and the default is CoS 0.
•
Lossless Remap Priority — The FCoE lossless remap priority of the
port. Valid values are CoS 0 through CoS 6, and the default is
CoS 0.