Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 1217)

Brocade Network Advisor IP User Manual 1163
53-1002947-01
Configuration rules
38
• Configuration the lines below list — Not available in the View Condition dialog box.
• Configuration text box — The configuration lines with which you want to compare the
product configuration.
• Lines in exact order check box — Not available in the View Condition dialog box.
• Remediation text box — Details how to correct the failure, if the condition fails.
Remediation content displays in the Configuration Rule Report for each failed condition.
The remediation detail cannot be over 1024 ASCII characters.
6. Click Cancel on the View Condition dialog box.
7. Click Cancel on the Add Configuration Rule dialog box.
8. Click Cancel on the Add Monitor dialog box.
9. Click Close on the Policy Monitor dialog box.
Adding a configuration condition
1. Select Monitor > Policy Monitor.
The Policy Monitor dialog box displays.
2. Click Add.
The Add Monitor dialog box displays.
3. Click the Switch/Router Checks tab.
4. Select Add > Configuration Rule.
The Add Configuration Rule dialog box displays.
5. Select Add > Condition.
The Add Condition dialog box displays ( Figure 456 ).
FIGURE 456 Add Condition dialog box