Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 471)

Brocade Network Advisor IP User Manual 417
53-1002947-01
Configuration repository management
14
Keeping a copy past the defined age limit
NOTE
This feature requires a Trial or Licensed version.
1. Select Configure > Configuration > Configuration Repository.
The Switch Configuration Repository dialog box displays.
2. Select the check box under Keep for the configuration you want to preserve. The configuration
will be kept until it is manually deleted, or until the Keep check box is cleared to enable the age
limit again.
3. Click OK.
Replicating configurations
NOTE
Only available for Fabric OS products.
NOTE
This feature requires a Trial or Licensed version.
You can replicate a switch SNMP configuration, the Fabric Watch configuration, Trace Destination
configuration, or the entire configuration.
Select Configure > Configuration > Replicate > Configuration.
A wizard is launched to guide you through the process. The first step of the wizard, Overview,
displays. There are seven steps in the Replicate Switch Configuration:
1. Overview, which describes the wizard.
2. Configuration Type, which allows you to select the type of configuration you wish to replicate.
For more information about the fields and components of this step, refer to Table 41 on
page 418.
3. Source Location, which allows you to select the location of the configuration you wish to
replicate. For more information about the fields and components of this step, refer to Table 42
on page 418.
4. Source Configuration, which allows you to select the source switch to replicate. For more
information about the fields and components of this step, refer to Table 43 on page 418.
5. Destination Switches, which allows you to select the destination switch. For more information
about the fields and components of this step, refer to Table 44 on page 420.
6. Validation, which lists the configuration settings that you can validate before you replicate. For
more information about the fields and components of this step, refer to Table 45 on page 421.
7. Summary, which lists the replication settings that successfully ran on all the selected
destination switches. For more information about the fields and components of this step, refer
to
Table 46 on page 421.
To proceed to the next step in the wizard, click Next. To return to the previous screen, click Previous.