Port actions, Enabling port actions, Disabling port actions – Brocade Network Advisor IP User Manual v12.1.0 User Manual
Page 393: Enabling port actions disabling port actions
Brocade Network Advisor IP User Manual
339
53-1002947-01
Port actions
9
Port actions
The Management application allows to you enable and disable port actions, display the port
properties of the Network OS device to which the FCoE WWN is attached, as well as access
performance monitoring from the Port tab of the Properties dialog box.
Enabling port actions
To enable port actions, complete the following steps.
1. Select one of the following view types from the view list on the Product List toolbar.
•
Network Object
•
IP Topology
•
L2 Topology
•
Ethernet Fabrics
•
VLAN Topology
2. Right-click the device in the Product List and select Properties.
The Device_Name Properties dialog box displays.
3. Click the Port tab.
4. Select Enable from the Port Actions list.
NOTE
If the VDX FC Port is enabled through the Properties dialog box, the Port Status displays as
"No_Light”. To obtain the updated value, re-open the Properties dialog box after the next
collection cycle.
5. Click OK to close the dialog box.
Disabling port actions
To disable port actions, complete the following steps.
1. Select one of the following view types from the view list on the Product List toolbar.
•
Network Object
•
IP Topology
•
L2 Topology
•
Ethernet Fabrics
•
VLAN Topology
2. Right-click the device in the Product List and select Properties.
The Device_Name Properties dialog box displays.
3. Click the Port tab.
4. Select Disable from the Port Actions list.
5. Click OK to close the dialog box.