Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 717)

Brocade Network Advisor IP User Manual 663
53-1002947-01
Layer 3 access control list policy
20
Service group configuration
The Management application allows you to filter traffic from a specific service group. A service
group is made up of one or more port ranges, services, or service groups. Use the following
procedures to configure a service group:
• “Viewing existing service groups” on page 663
• “Creating a service group” on page 664
• “Editing a service group” on page 665
• “Copying a service group” on page 666
• “Deleting a service group” on page 667
Viewing existing service groups
You can access the Service dialog box when configuring an extended L3 ACL device configuration.
To configure an extended L3 ACL, refer to one of the following procedures:
• “Creating an extended L3 ACL configuration” on page 632
• “Editing an extended L3 ACL configuration” on page 635
• “Copying an extended L3 ACL configuration” on page 636
• “Creating an extended L3 ACL configuration” on page 632
• “Editing an IPv6 L3 ACL configuration” on page 639
• “Copying an IPv6 L3 ACL configuration” on page 640
To view all existing service groups, complete the following steps.
1. Click the Service Groups tab.
FIGURE 234 Service dialog box, Service Group tab
2. Review the List of Service Groups table:
• Name — The service group name.
• Port Range — The range (1 — 65535) of port numbers.
• Services — The name of each service in the service group.
• Service Groups — The name of each service group in the service group.