Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 276)

222 Brocade Network Advisor IP User Manual
53-1002947-01
User profiles
7
3. Enter the user name for the product in the Product Login Account - Username field.
4. Enter the password for the product in the Product Login Account - Password field.
NOTE
If Telnet is used to log in to the device and Telnet only requires a password, then enter the
password in the Password field and leave the Username field blank.
5. (IronWare only) Enter the user name assigned to management privilege levels on the device in
the Product Enable Account - Username field.
6. (IronWare only) Enter the password assigned to management privilege levels on the device in
the Product Enable Account - Password field.
NOTE
If a device only requires the enable password, then enter the password in the Password field
and leave the Username field blank.
7. Click OK on the CLI Credential dialog box.
8. Click OK on the User Profile dialog box.
Once you configure the CLI credentials, you must turn on the CLI credential policy through the
Users dialog box.
Configuring the CLI credential policy
NOTE
You must have User Management Read and Write privileges to configure user accounts.
NOTE
This feature requires a Trial or Licensed version.
To configure the application to use the CLI login credentials of the user for all CLI deployments,
complete the following steps.
1. Select Server > Users.
The Users dialog box displays.
2. Click the Policy tab.
3. Select the Use User CLI Credential check box in the CLI Credential area.
A confirmation message displays. Click Yes on the message.
Make sure to configure the User CLI Credentials in the User Profile dialog box (refer to
“Configuring CLI credentials” on page 221). These credentials will be used for all CLI
deployments and will override the CLI credentials configured during discovery or in the CLI
template.
4. Click OK on the Users dialog box.