Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 477)

Brocade Network Advisor IP User Manual 423
53-1002947-01
Configuration repository management
14
TABLE 49 Step 4. Select Destination Switches
Field/Component Description
Available Switches table Lists the available switches you can select to be applied to the selected
switches table.
Name The name of the available switch.
Device Type The type of device port.
Tag The tag number of the port.
Serial # The serial number of the switch.
WWN The switch port’s world wide name.
IP Address The switch port’s IP address.
Domain ID The switch port’s top-level addressing hierarchy of the domain.
Vendor The hardware vendor’s name.
Model The name and model number of the hardware.
Port Count The total number of ports.
Firmware The firmware version.
Location The customer site location.
Contact The primary contact at the customer site.
Description A description of the customer site.
State The port state, for example, online or offline.
Status The operational status of the port; for example, unknown or marginal.
Right and left arrow buttons Click to move the switches back and forth between the Available
Switches table and the Selected Switches table.
Selected Switches table Lists the switches selected as the destination switches.
Switch Name The name of the switch selected to be the destination switch.
IP The IP address of the switch selected to be the destination switch.
WWN The world wide name of the switch selected to be the destination switch.
Current Firmware Status The status of the current firmware.
TABLE 50 Step 5. Validation
Field/Component Description
Validation Settings table The replication settings that have been configured in previous steps; for
example, the configuration type, source configuration, and destination
settings. Click Finish to approve the settings.
Disable Destination Switch check box Select to disable the destination switch during replication.
TABLE 51 Step 6. Summary
Field/Component Description
Summary table The replication settings that have been successfully applied to the
selected destination switches; for example, the configuration type,
source configuration, and destination settings. Click Close to close the
dialog box.