Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 1214)

1160 Brocade Network Advisor IP User Manual
53-1002947-01
Configuration rules
38
12. To move a condition or block down in the rule, select one condition or block (except the last
item) and click Move Down.
You can only move one item (condition or entire block) down at a time. If you move a condition
from the first position in the rule or in a block, the logical operator (AND/OR column) is
automatically populated. You can move a condition into a block by moving it between the start
and end of a block. If the condition is already part of the block, it skips the block and moves
below the block.
13. To find a condition or block in the Selected Conditions/Blocks list, select a condition or block in
the Library list and click Find > (right arrow).
The condition or block is highlighted in the Selected Conditions/Blocks list.
14. To find a condition or block in the Library list, select a condition or block in the Selected
Conditions/Blocks list and click Find < (left arrow).
The condition or block is highlighted in the Library list.
15. To remove a condition or block from a rule, select one or more conditions and blocks in the
Selected Conditions/Blocks list and click the left arrow button.
16. Click OK on the Add Configuration Rule dialog box.
17. Click OK on the Add Monitor dialog box.
The updated policy monitor displays in the Monitors table of the Policy Monitor dialog box.
18. Click Close on the Policy Monitor dialog box.
Duplicating a configuration rule
You can create a new configuration rule based on a predefined or user-defined configuration rule.
1. Select Monitor > Policy Monitor.
The Policy Monitor dialog box displays.
2. Click Add.
The Add Monitor dialog box displays.
3. Click the Switch/Router Checks tab.
4. Select the configuration rule (either predefined rule or user-defined) you want to duplicate in
the Available Checks list or Selected Checks list.
5. Click Add > Configuration Rule.
The Add Configuration Rule dialog box displays.
6. Change the name for the rule in the Name field.
The name cannot be over 128 characters. The only special characters allowed are an
underscore (_) or space.
7. Change the description for the rule in the Description field.
The description cannot be over 1024 ASCII characters.
8. To edit the configuration rule, repeat step 7 through step 15 of “Adding a configuration rule” on
page 1158.
9. Click OK on the Add Configuration Rule dialog box.