Filtering real-time performance data, Graph display, Filtering real-time performance data 8 – Brocade Network Advisor IP User Manual v12.1.0 User Manual
Page 1072
1018
Brocade Network Advisor IP User Manual
53-1002947-01
SAN real-time performance data
35
Filtering real-time performance data
To filter real-time performance data from the Real Time Performance Graphs dialog box, complete
the following steps.
1. Open the Real Time Performance Graphs dialog box.
For step-by-step instructions, refer to
“Generating a real-time performance graph”
2. Select how the data is measured, in received frames, transmitted frames, or CRC errors.
For a list of possible performance measures, refer to
3. To select more than one measure, click the Additional Measures expand arrows and select the
check box for each additional measure. If Additional Measures area is not shown, click the
down arrow.
For a list of possible performance measures, refer to
4. (Optional) Enter a value (percentage) in the Reference Line field to set a reference for the
transmit and receive utilization.
Note that this field is only available when you select Tx % Utilization or Rx % Utilization from the
Measures list.
5. Select how detailed the data will display from the Granularity list. Options are in increments of
10 seconds, 15 seconds, 20 seconds, 25 seconds, 30 seconds, 45 seconds, or 1 minute.
6. Select Plot Events to display advanced monitoring service (AMS) violation events received
during the chart time range and Master Log events logged on the same product as the
measure being plotted.
7. Move the Row Height slider to the left to make the row height smaller or to the right to make it
larger.
8. Select the Display tabular data only check box to show only text with no graphs or icons.
The Source and Destination icons and the Graph column do not display.
9. Click Apply.
The selected data automatically displays in the Real Time Performance Graphs dialog box.
10. Click the close button (X) to close the Real Time Performance Graphs dialog box.
Graph display
The columns in the graphical portion of the Real Time Performance Graphs dialog box display the
following information:
•
Source Fabric - The source fabric being monitored.
•
Source - The source device being monitored.
•
Source Port - The source port being monitored.
•
Tunnel ID - The ID of the FCIP tunnel being monitored.
•
Destination Fabric - The destination fabric.
•
Description - Description of the FCIP tunnel.