Brocade Network Advisor IP User Manual v12.1.0 User Manual
Page 1068
1014
Brocade Network Advisor IP User Manual
53-1002947-01
SAN performance overview
35
Priv Protocol [DES(1)/noPriv(2)/3DES(3)/AES128(4)/AES2(5)/AES256(6)]):
(2..2) [2]
User (ro): [snmpuser1]
Auth Protocol [MD5(1)/SHA(2)/noAuth(3)]: (1..3) [3]
Priv Protocol [DES(1)/noPriv(2)/3DES(3)/AES128(4)/AES2(5)/AES256(6)]):
(2..2) [2]
User (ro): [snmpuser2]
Auth Protocol [MD5(1)/SHA(2)/noAuth(3)]: (1..3) [3]
Priv Protocol [DES(1)/noPriv(2)/3DES(3)/AES128(4)/AES2(5)/AES256(6)]):
(2..2) [2]
User (ro): [snmpuser3]
Auth Protocol [MD5(1)/SHA(2)/noAuth(3)]: (1..3) [3]
Priv Protocol [DES(1)/noPriv(2)/3DES(3)/AES128(4)/AES2(5)/AES256(6)]):
(2..2) [2]
SNMPv3 trap recipient configuration:
Trap Recipient's IP address : [2.168.71.32]
UserIndex: (1..6) [1]
Trap recipient Severity level : (0..5) [4]
Trap recipient Port : (0..65535) [162]
Trap Recipient's IP address : [1.1.1.1]
UserIndex: (1..6) [2]
Trap recipient Severity level : (0..5) [4]
Trap recipient Port : (0..65535) [162]
Trap Recipient's IP address : [10.64.209.171]
UserIndex: (1..6) [1]
Trap recipient Severity level : (0..5) [4]
Trap recipient Port : (0..65535) [162]
Trap Recipient's IP address : [0.0.0.0]
Trap Recipient's IP address : [0.0.0.0]
Trap Recipient's IP address : [0.0.0.0]
-
To check SNMP credentials in the Management application, complete the following steps.
1. Select Discover > Fabrics.
The Discover Fabrics dialog box displays.
2. Select an IP address from the Available Addresses list.
3. Click Edit.
The AddFabric Discovery dialog box displays.
4. Select the Manual option to view SNMP credentials.
5. Click the SNMP tab.
6. Select v1 or v3 from the SNMP Version list.
7. Make sure SNMP credentials match those on the device.
8. Click OK on the AddFabric Discovery dialog box.
9. Click Close on the Discover Fabrics dialog box.
-
To set SNMP credentials in the Management application, refer to
•
Make sure that the SNMP security level is set to the appropriate level for the switch.
-
To check the SNMP security level, use the snmpconfig --show secLevel command.
Example of checking SNMP security level
snmpconfig --show secLevel
GET security level = 0, SET level = 0
SNMP GET Security Level: No security