Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 704)

650 Brocade Network Advisor IP User Manual
53-1002947-01
Layer 3 access control list policy
20
1. Click the Networks tab.
FIGURE 228 Network dialog box, Networks tab
2. Review the List of Networks table:
• Name — The user-defined network name.
• Subnet — The IP address of the subnet.
• Mask — The IP address of the mask.
3. Click Close on the Network dialog box.
To finish configuring the ACL, return to one of the above procedures.
Creating a network
You can access the Network dialog box when configuring a standard or extended L3 ACL device
configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:
• “Creating a standard L3 ACL configuration” on page 628
• “Editing a standard L3 ACL configuration” on page 630
• “Copying a standard L3 ACL configuration” on page 631
• “Creating an extended L3 ACL configuration” on page 632
• “Editing an extended L3 ACL configuration” on page 635
• “Copying an extended L3 ACL configuration” on page 636
To create a network, complete the following steps.
1. Click the Networks tab.
2. Click Add.
The Add Network dialog box displays.
FIGURE 229 Add Network dialog box