Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 1212)

1158 Brocade Network Advisor IP User Manual
53-1002947-01
Configuration rules
38
• Selected Conditions/Block list — Contains the logical expression of one or more conditions
and blocks for the rule.
The Selected Conditions/Block list contains the following details:

AND/OR — To change the logical operator separator, select AND or OR from the
AND/OR column.
Valid values include AND and OR. The first item in a rule and the first connector in a
block display empty fields and cannot be edited. Each condition or block you add
displays with an AND connector (except the first item) in the list of conditions or
blocks. If you add one or more conditions to a block, each condition displays with an
OR connector (except the first condition) in the block.
Fields containing a green triangle ( ) in the lower right corner are editable.

( — Enter an open parenthesis to start a group (a set of conditions and blocks).
You can create up to three groups. You can nest groups. To ungroup a group, clear the
( and ) columns that delineate the group.

Condition — A list of conditions and blocks included in the rule.

) — Enter a close parenthesis to close a group (a set of conditions and blocks).
You can create up to three groups. You can nest groups. To ungroup a group, clear the
( and ) columns that delineate the group.

Move Up button — Use to move a condition or block up in the rule (except the first
item).
You can only move one item (condition or entire block) up at a time. If you move a
condition to the first position in the rule or in a block, the logical operator (AND/OR
column) is cleared. You can move a condition into a block by moving it between the
start and end of a block. If the condition is already part of the block, it skips the block
and moves above the block.

Move Down button — Use to move a condition or block down in the rule (except the
last item).
You can only move one item (condition or entire block) down at a time. If you move a
condition from the first position in the rule or in a block, the logical operator (AND/OR
column) is automatically populated. You can move a condition into a block by moving it
between the start and end of a block. If the condition is already part of the block, it
skips the block and moves below the block.
5. Click Cancel on the Add Configuration Rule dialog box.
6. Click Cancel on the Add Monitor dialog box.
7. Click Close on the Policy Monitor dialog box.
Adding a configuration rule
You can create your own rules to compare content against a baseline.
1. Select Monitor > Policy Monitor.
The Policy Monitor dialog box displays.
2. Click Add.
The Add Monitor dialog box displays.
3. Click the Switch/Router Checks tab.