Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 1203)

Brocade Network Advisor IP User Manual 1149
53-1002947-01
Adding a policy monitor
38
7. To set policy monitors for switches, select the Switch/Router Checks tab ( Figure 452 ) and
complete the following steps.
FIGURE 452 Add Policy Monitor dialog box, Switch/Router Checks tab
a. Select one or more of the following checks in the Available Checks list to include them in
the policy monitor:
For more information about these checks and fixes for rule violations, refer to “Switch and
router policy monitors” on page 1139.
NOTE
The Check for HTTPS (secure HTTP) configuration are not supported on Network OS
products and the following IronWare products: Ethernet Core routers, Ethernet Carrier
Routers, Ethernet Edge router, and Data Center switch, as well as the 6650 Ethernet
switch, router, and L3 router..
NOTE
The Check for Secure SSH (secure Telnet) configuration checks are not supported on the
following IronWare products: Application products running 12.3.X or earlier and the 6910
Ethernet switch.
• Select the Check if the product is configured to send events to this server check to
determine if the Management application server is registered as an SNMP recipient
and Syslog recipient.
• Select the Check for HTTPS (secure HTTP) configuration check to check each target to
see if HTTPS is active for device data transmission.
• Select the Check for SSH (secure Telnet) configuration check to check each target to
see if SSH is enabled for device data transmission.