Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 232)

178 Brocade Network Advisor IP User Manual
53-1002947-01
Software Configuration
6
3. (Fabric OS and Network OS products only) Select IPv4 (default) or IPv6 to set the preferred IP
format.
4. Click Apply or OK to save your work.
Changes to this option take effect after an application restart.
5. Click OK on the “changes take effect after application restart” message.
Configuring IP communication
To configure communication between IP product and the Management application server,
complete the following steps.
1. Select Server > Options.
The Options dialog box displays.
2. Select Product Communication from the Software Configurations list in the Category pane.
The Product Communication pane displays ( Figure 69 ).
FIGURE 69 Options dialog box (Product Communication pane)
3. To connect to products using SSH, complete the following steps.
a. Select the SSH only option.
b. Enter the connection port number in the SSH Port field. Go to step 6 .
The default SSH port number is 22.
4. To connect to products using Telnet, select the Telnet only option. Go to step 6 .
5. To connect to products using SSH then Telnet, complete the following steps.
a. Select the SSH then Telnet option.
b. Enter the connection port number in the SSH Port field. Continue with step 6 .
6. Select one of the following options to determine configuration file transfer communication:
• SCP only
• TFTP only