Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 707)

Brocade Network Advisor IP User Manual 653
53-1002947-01
Layer 3 access control list policy
20
3. Click Yes on the confirmation message.
4. Click Close on the Network dialog box.
To finish configuring the ACL, return to one of the above procedures.
Network group configuration
The Management application allows you to filter traffic from a specific network group. A network
group is made up of one or more devices, networks, or network groups. Use the following
procedures to configure a network:
• “Viewing existing network groups” on page 653
• “Creating a network group” on page 654
• “Editing a network group” on page 655
• “Copying a network group” on page 656
• “Deleting a network group” on page 658
Viewing existing network groups
You can access the Network dialog box when configuring a standard or extended L3 ACL device
configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:
• “Creating a standard L3 ACL configuration” on page 628
• “Editing a standard L3 ACL configuration” on page 630
• “Copying a standard L3 ACL configuration” on page 631
• “Creating an extended L3 ACL configuration” on page 632
• “Editing an extended L3 ACL configuration” on page 635
• “Copying an extended L3 ACL configuration” on page 636
To view all existing network groups, complete the following steps.
1. Click the Network Group tab.
FIGURE 230 Network dialog box, Network Group tab