Adding a pseudo event on the resolving policy – Brocade Network Advisor IP User Manual v12.1.0 User Manual
Page 1281
Brocade Network Advisor IP User Manual
1227
53-1002947-01
Pseudo events
39
17. If you want an epilogue to be placed at the end of the e-mail message, enter up to 255
characters in the Body Epilogue field.
NOTE
The prologue, the event action message, and the epilogue form the body of the e-mail alert.
18. Click Next to advance to the Summary pane.
19. Click Finish.
The Summary pane of the Add Event Action dialog box displays an overview of the e-mail
configuration you are creating.
For more information about adding an event action, refer to
Adding a pseudo event on the resolving policy
When a down event occurs, a resolving policy waits for a specified duration to see if the event
remains in that state by checking if an up event occurs. If an up event occurs, a resolving pseudo
event is generated by the Event Processor.
The following two-part procedure uses both the Add Pseudo Events dialog box and the Add Event
Actions dialog box to create an event action with the resolving policy.
To add a pseudo event definition to the resolving policy, complete the following steps.
1. Select Monitor > Event Processing > Pseudo Events.
The Pseudo Events dialog box displays.
2. Click Add.
The Identification pane of the Add Pseudo Event dialog box displays.
3. Enter a name for the pseudo event, and select the Enabled check box to enable the event.
4. Click Next.
The Policy pane of the Add Pseudo Event dialog box displays.
5. Click the Resolve button, and then enter the duration of time the Event Processor will wait
before generating the pseudo event. Specify the resolve time in minutes or seconds.
6. Click Next.
The Events pane of the Add Pseudo Event Events dialog box displays.
7. Select a critical event, such as LinkDown, and click the right arrow button to move it to the
Selected Down Trap list.
8. Select a remediation event, such as LinkUp, and click the right arrow button to move it to the
Selected Up Trap list.
9. Click Finish to complete the pseudo event configuration.
Now, you must create a new event action definition using the Add Event Actions dialog box.