Agilent Technologies Agilent E5250A - Manual (Page 73)

Agilent E5250A User’s Guide, Edition 11 4-3
Setting up Measurement Environment
Connector Plates
Connector Plates
A connector plate is the interface to connect the E5250A to your prober or test
fixture. The following connector plates are available for the E5250A. To install the
connector plate, refer to Agilent 16495 Installation Guide.
Connector Plates for the E5252A
16495F Half size connector plate for E5252A
16495F-001 has 12 triaxial through connectors (female to
female), an Intlk connector, and a GNDU connector (triaxial
through, female to female). The back of the Intlk connector is
designed for soldering.
16495F-002 has 12 triaxial connectors, an Intlk connector, and
a GNDU connector. The back of each connector is designed for
soldering.
16495G Full size connector plate for E5252A
16495G-001 has 24 triaxial through connectors (female to
female), an Intlk connector, and a GNDU connector (triaxial
through, female to female). The back of the Intlk connector is
designed for soldering.
16495G-002 has 24 triaxial connectors, an Intlk connector, and
a GNDU connector. The back of each connector is designed for
soldering.
Connector Plates for E5255A
16495C Half size connector plate for E5255A
The 16495C has six 8-channel shielded coaxial connectors, an
Intlk connector, and a GNDU connector. The back of each
connector is designed for soldering.
16495D Full size connector plate for E5255A
The 16495D has twelve 8-channel shielded coaxial connectors,
an Intlk connector, and a GNDU connector. The back of each
connector is designed for soldering.