ETC Cobalt Family v7.1.0 - Manual (Page 1011)

Cobalt 7.1 - 20140612
1010
MIDI - Standard MIDI
All MIDI functions need to be activated in the MIDI Setup. See System Settings - MIDI .
MIDI NOTES & CONTROLLERS
All keys and faders can send notes and controllers when this is activated in the MIDI Settings.You can
use MIDI notes and controllers to remote control any key or fader of the Console. If you connect a
MIDI Sequencer you can record all key presses and fader movements in real time and play back in
real time.
PROGRAM CHANGE
The Cobalt can be set to activate a specific crossfade when receiving a Program Change command
through MIDI. When the Program Change parameter (in MIDI Settings)is set to "On" the board will
activate a crossfade to step 0-127 when receiving Program Change 0-127.
NOTE
You have to have a Sequence Step recorded in the board to be able to jump to
it.
You have to send both ON and OFF for notes.