ETC Cobalt Family v7.1.0 - Manual (Page 1042)

Cobalt 7.1 - 20140612
1041
Examples
Function Key Feedback
1. Select channel 1 and set
a level [1] [Level_Wheel] Channel 1 is marked in
orange as selected, and the
level is set by the wheel.
2. Select channel 2 and set
a level [2] [Level_Wheel] Channel 1 is left at its level,
channel 2 is selected and
marked in orange. The
level is set by the wheel.
3. Select both and set them
to full [ALL] [Level_Wheel] All channels with a level
connected to the channel
control are selected (1&2).
The level is set by the
wheel.
Record This To Master 1
You can record the output of the selected channels to a Master Playback.
Function Key Feedback
1. Select the channels [ALL] All channels with a level in
the channel control are
selected. Should be 1 & 2
that you set a level to in the
previous example.
2. Record to Master 1 [RECORD] &
[Master_Key1]
Hold RECORD and press
the grey key over Master 1.
You will get a Record
popup asking you to
confirm.
3. Confirm [RECORD] The preset is stored to
Master 1 as preset 801, and
the number is indicate in
the graphical display over
the master fader.
NOTE
The same light is still output from the Channel Control (A). Clear this by
selecting all channels and fading to zero with the wheel.
Now test fading up Master fader 1. The channels should be fading up on stage and on the channel
screen. Fade down the Master again so that there is no light on stage.