ETC Cobalt Family v7.1.0 - Manual (Page 1029)

Cobalt 7.1 - 20140612
1028
Press MODIFY in this cell to re-query or store the cache (see options below)
Options (press MODIFY to activate)
"Querying device structure..."
- This is a status that a query is going on
"Device structure available. Save to cache?"
- There is a structure, you can save it to cache manually (it is done at shutdown automatically). It will
be loaded at the next restart of Cobalt.
"Using cached device structure. Delete cache?"
- Will delete the cached structure, and allow a re-query. It will be done at the next restart of Cobalt.
"Restart to use cache"
- The cache is now stored and att the next restart Cobalt will start using it automatically.
"Restart to re-query"
- At the next restart of Cobalt, a new query will be performed.
RDM Device Parameter List
The Device Parameter List provides access to the settings of each device that can be seen and
controlled over RDM. This list is only available when there are discovered RDM devices. It is opened
from the RDM Device List by pressing MODIFY in the Parameter cell of the device you wish to
adjust. Note that regardless of which device you use to open this tab, it will show all devices of that
model in the same table.
All data in this tab is generated by the RDM device and is then displayed by Cobalt. Parameters you
can edit are shown in white text. Changes you make in this tab are sent directly to the device and are
not stored in any way by Cobalt. The valid data for a parameter is wholly dependent on the way the
device manufacturer has developed their RDM functionality. Valid input may be numerical (type the
new value and press MODIFY) or may be entered using a drop down menu (usually shown in text).
Consult the user manual for the device to understand the impact of changing parameters in this tab.