ETC Cobalt Family v7.1.0 - Manual (Page 181)

Cobalt 7.1 - 20140612
180
Play Settings - Introduction
Press SETUP in the programming section to open system settings. You can also open a local settings
popup for any key by holding SETUP and pressing that key (for example GO or RECORD)
The system settings popup contains the following sections
• LETS BEGIN >A summary of the most important settings.
• CHANNELS >Configure default values and select Command Syntax.
• CROSSFADE >Configure default times, fader modes and fade direction.
• MASTERS >Configure Flash and fade on time and Auto-save master pages.
• EFFECTS >Configure "Remember Effect Parameters".
• SYSTEM >Configure Auto-save, rubberband, beep, remote etc.
• ATTRIBUTES >Configure default times and recording modes.
• MIDI >Midi Settings
• SHOW CONTROL >Configure Midi, Show Control and Time Code.