ETC Cobalt Family v7.1.0 - Manual (Page 683)

Cobalt 7.1 - 20140612
682
If your Cobalt is set to use At Mode for channel commands, effects are selected in the following ways.
You can terminate a selection in At Mode pressing @Level or the decimal point.
Action Key Feedback
Select effect [EFFECT] [#] Effect # is selected
Add an effect
[+] [EFFECT] [#] Effect # is added to the
current selection
Subtract an effect [-] [EFFECT] [#] Effect # is subtracted from
the current selection
Add multiple effects [THRU] [#] Up to effect # is added to
the current selection
Add a channel
[+] [CHANNEL] [#]
Channel # is added to the
current selection
Add a group [+] [GROUP] [#] Effect # is added to the
current selection
Subtract a channel [-] [CHANNEL] [#] Channel # is subtracted
from the current selection
Subtract a group [-] [GROUP] [#] Effect # is subtracted from
the current selection
Select channels from effect
These functions make it possible to select channels involved in an effect.
Action Key Feedback
Select active channels [EFFECT] &
[CHANNEL] All channels involved in
effects that are active are
selected.
Select all in effect... [#] [EFFECT] &
[CHANNEL] All channels involved in
effect playback # are
selected.
Select active effects
[EFFECT] & [ALL]
or
[ALL] & [EFFECT]
All active effect playbacks
are selected. Pressing ALL
alone will never select
effect playbacks.
Toggle between selecting
an effect and the channels
assigned to it. [Inv_Eff/Ch]
or
[C/Alt] & [INV
GROUP] The soft key Inv Eff/Ch in
the Effects soft key meny
allow you to toggle the
channel selection between
the selected effect playback
and the channels assigned
to it.