ETC Cobalt Family v7.1.0 - Manual (Page 986)

Cobalt 7.1 - 20140612
985
[1] [#] [SHIFT] [CHANNEL] [SHIFT] [100%]
If a console is set to work in At Mode, channel selection functions on the remote behave differently.
For example:
Set channels 1 thru 5 to 55%
[1] [SHIFT] [THRU] [5] [SHIFT] [@Level] [5] [5]
Set channels 1 thru 6 at full
[1] [SHIFT] [THRU] [6] [SHIFT] [100%]
Note: When recording from the remote, only levels set from the remote are recorded, not the whole
stage output.
Note: To enable recording from remote, check the setup option "Allow recording from remote"