ETC Cobalt Family v7.1.0 - Manual (Page 468)

Cobalt 7.1 - 20140612
467
Channels - Ch Only Mode
The CH ONLY MODE key in the programming section allows a complete novice to get some lights
on stage. It converts all 40 Playback faders to channel faders temporarily, actually turning the console
into a single scene board.
Action Console Feedback
1. Make sure the Grand
Master is up
Grand Master Otherwise there is no light
output
2. Make sure the FREEZE
switch is set to ON Freeze Switch Otherwise there is static, or
no light output
3. Activate channel only
mode [CH_ONLY_MODE] Channels 1-40 can be
accessed from the Master
faders now. Move fader 1
and you can see the value
for channel 1 on the
channel views.
You can select a channel
range from the Direct
Select keys. Direct Select keys The channels in each range
are indicated in the
displays.
The levels will remain when you exit Channel Only mode and can be used in the normal mode.
To exit Channels Only Mode, press again.