ETC Cobalt Family v7.1.0 - Manual (Page 471)

Cobalt 7.1 - 20140612
470
Permanent Capture Mode
While Capture mode is activated, all channels that are changed are automatically captured.
Action Key Feedback
Activate [CAPTURE] [CAPTURE] Capture will light up. All
channels that are selected and
changed will remain at that
level until released.
Deactivate [CAPTURE] [CAPTURE] Capture light goes off.
Captured channels remain
captured until released.
Captured channels will have a
red background for the channel
number.
Capturing levels or parameters
Regardless if Capture mode is active or not, it is always possible to capture channels or part of
channels. Capture mode is not toggled to a permanent active state by these commands (5.0).
OBSERVE
That all of these commands will affect the currently selected channels. If a number is entered first,
only this channel will be affected.
Action Key Feedback
Intensity and
parameters [CAPTURE] &
[CHANNEL] Captured channels will have a
red background for the channel
number.
Intensities [CAPTURE] & [@LEVEL] Level is captured until released.
Parameters [CAPTURE] & [ATTRIB] Parameters are captured until
released.
Single Parameters [CAPTURE] &
[Wheel_key]
Parameters are captured until
released.
Focus parameters [CAPTURE] & [FOCUS] Parameters are captured until
released.
Color parameters
[CAPTURE] & [COLOR]
Parameters are captured until
released.
Beam parameters [CAPTURE] & [BEAM] Parameters are captured until
released.
U1-U3 parameters [CAPTURE] & [U1-U3] Parameters are captured until
released.