ETC Cobalt Family v7.1.0 User Manual
Page 197
Cobalt 7.1 - 20140612
196
Standard MIDI
All keys and faders can send notes and controllers when this is activated in the MIDI Settings.You can
use MIDI notes and controllers to remote control any key or fader of the Console.The Cobalt can also
be set to activate a specific crossfade when receiving a Program Change command through MIDI. See
MIDI
.
Function
Explanation
Default value
Direct mode
Midi
Direct Mode
On
MIDI Channel
The MIDI channel used by Cobalt
1
Keys
All keys are sent as notes.
Off
Faders
All faders are sent as controllers.
Off
Program Change
Jumps to sequence step #
-
MIDI Show control
Cobalt supports sending and receiving of MIDI Show Control (MSC) commands. See
MIDI - MIDI
Show Control
.
Function
Explanation
Default value
Enable
Activates reception of MSC.
Off
Device ID
Sets a Device ID for this Cobalt.
1
Time Code
Every sequence step can be triggered both manually, and by a specific MIDI Time Code time on the
MIDI port. See
MIDI - Time Code
.
Function
Explanation
Default value
Time Code
MIDI Times Code reception is on.
Off
Learn mode
Activate learn mode for setting
Time Code to Sequence Steps.
Off
Auto-locate step
Sets if Time Code should auto-
locate steps or not.
Off
Enable Backup clock
Enables the backup clock
Off
Internal clock start
Sets a start time for the internal
clock.
--.--.--.--