ETC Cobalt Family v7.1.0 - Manual (Page 466)

Cobalt 7.1 - 20140612
465
Selecting Decimal Channels (7.1)
Channel RPN AT MODE
Select complete device [1] [CHANNEL] [1]
Select only base channel [1] [.] [0]
[CHANNEL]
[1] [.] [0]
Select only decimal
channels
[1] [.] [1]
[CHANNEL] [1] [.] [1]
Invert base/decimal [INVERT] & [.] [INVERT] & [.]
Set Channel Levels
Once a channel(s) is selected you can set levels in the following ways.
Level Command RPN AT MODE
Set to 50% [5] [0]
[@LEVEL] [@LEVEL] [0] [5]
Set to 55% [5] [5]
[@LEVEL] [@LEVEL] [5] [5]
Set to 100%
[@LEVEL]
[@LEVEL] [@LEVEL] [@LEVEL]
Set to 70%*
[@LEVEL] [@LEVEL] [7]
Set to 0% [@LEVEL]
[@LEVEL]
[@LEVEL] [@LEVEL] [@LEVEL]
[@LEVEL]
Set to 0% [C/Alt] & [-%] [C/Alt] & [-%]
Add 5% [+%] [+%]
Subtract 5% [-%] [-%]
Select ch # and add 5%
[#] [+%] [#] [+%]
Select ch # and subtract 5% [#] [-%] [#] [-%]
Increase level by #% [#] [.] [+%] not possible in at mode
Diminish level by #% [#] [.] [-%] not possible in at mode
Revert to last used level
(Undo) [ON/FETCH] &
[@LEVEL] [ON/FETCH] & [@LEVEL]