ETC Cobalt Family v7.1.0 - Manual (Page 732)

Cobalt 7.1 - 20140612
731
Start Dynamics From The Effect Library Node
Action Key Feedback
1. Select the Browser [BROWSER]
The Browser is selected
and highlighted. If it was
already selected it is closed.
Press again to open.
2. Go to the Effect Library
node
Arrow keys Up/Down The Effect Library node is
highlighted.
3. Open the Effect Library
node Right arrow The Effect Library node is
opened.
4. Select an Effect Down arrow The selected Effect is
highlighted
5. Start the Effect [LOAD] The selected Effect is
activated for the currently
selected channel(s).
Start Dynamics From The Direct Selects
Action Key Feedback
1. Select Dynamics for a
section [TYPE] &
[Dynamics] When TYPE is held you
can select Dynamics for a
section. The first ten
dynamics are displayed in
the section immediately.
2. Activate a Dynamic Section keys 1-10 The selected Effect is
activated for the currently
selected channel(s).
See Direct Selects .
Start Dynamics With Direct Mode
1. Hold DYN EFFECT (don't let go until the Dynamics are started).
- When this is held, the first 40 Dynamic Effects in the Effect Library are displayed on the Direct
Select keys.
2. Activate a Dynamic by pressing the corresponding key
3. Let go of DYN EFFECT.