Desk – ETC Eos Titanium, Eos, and Gio v2.0.0 User Manual
Page 145
7
Setup
127
Desk
This setup softkey accesses settings for the specific Eos user. Changing these settings does not
impact other Eos controllers on the Eos network, unless they are set to the same user. Nine setting
buttons are available in desk settings: {Record Defaults}, {Manual Control}, {Face Panel}, {Face
Panel Keypad}, {Displays}, {PDF File Settings}, {Brightness Settings}, {Fader Wing Config},
{RFR Settings}, and {Trackball Settings}.
{Record Defaults}
This screen enables you to change general record defaults.
To change the setting for any of these fields, press the field in the CIA to activate it. If the field
requires data, enter it from the keypad. If the field is a toggle state, one press of the button will
switch the field to its other state.
Auto Playback
When enabled, this feature automatically plays back cues and submasters as they are stored and
releases manual control. For submasters to automatically play back, the slider must be at full. This
field is a toggle state between “Enabled” and “Disabled”. When auto playback is “Disabled”, all
manual levels are maintained and cues must be loaded and executed on playbacks. The default is
“Enabled”.
Track
This field allows you to switch between tracking and cue only modes (see
). The default is “Tracking”.
Record Confirm
This setting allows you to enable/disable the confirm action when storing over a previously
recorded target. The default is “Enabled”.
Delete Confirm
This field allows you to enable/disable a required confirmation before any delete command is
executed. The default is “Enabled”.
Update Mode
This field allows you to select a default update mode (see
). The default is
“All”.
Break Nested
This setting allows you to enable/disable the update modifier break nested. The default is
“Disabled”.
Update Last Ref
This setting allows you to enable/disable the update modifier update last ref. The default is
“Disabled”.